Mercedes-Benz Sprinter Twin Rear Tyre Pressure Reset (TPMS)
TPMS Reset / Tyre Pressure Monitor
How to reset / calibrate your Mercedes-Benz Sprinter Twin Rear tyre pressure monitoring system
Restarting the tyre pressure monitor
Requirements:
• The recommended tyre pressure is correctly set for the respective operating condition on each of the wheels.
• Restart the tyre pressure monitoring system in the following situations:
- The tyre pressure has changed.
- The wheels or tyres have been changed or newly fitted.
On-board computer:
► Service ► Tyres
► Scroll down in the menu.
► The Use current pressures as new reference values? message appears in the multifunction display.
► Confirm the message to initiate a restart.
The Tyre press. monitor restarted message appears in the multifunction display.
Current warning messages are deleted and the flat tyre yellow warning lamp goes out.
After you have driven for a few minutes, the system checks whether the current tyre pressures are within the specified range. The current tyre pressures are then accepted as reference values and monitored.
Before resetting the tyre pressure monitoring system for the Mercedes-Benz Sprinter Twin Rear
Check the tyres first
A reset does not repair a puncture or restore lost air. Check all tyres and set the correct cold pressures before following the reset instructions. If a tyre repeatedly loses pressure, have the cause investigated rather than repeatedly clearing the warning.
Follow the correct system procedure
Vehicles use different monitoring systems. Some store a reference after adjustment, while others use pressure sensors and may need a relearn procedure. Follow the instructions for this vehicle; a menu sequence from another model may not apply.
If the warning returns
Recheck the pressures and inspect for damage. A persistent or flashing warning can indicate a system fault as well as a pressure issue; use the vehicle handbook to identify it. TPMS does not replace routine manual pressure checks.