TYRE SIZE:WHEEL TORQUE:FRONTREARSTANDARD
LOADECOFULLY
LADENkPaPSIkPaPSI2904225036————3104531045265/35R20120 Nm
LOADECOFULLY
LADENkPaPSIkPaPSI2904225036————3104531045265/35R20120 Nm
Standard Load Tyre Pressures
Front: 42 PSI (2.9 bar / 290 kPa) - Rear: 36 PSI (2.5 bar / 250 kPa)
Fully Laden Pressures
Front: 45 PSI (3.1 bar / 310 kPa) - Rear: 45 PSI (3.1 bar / 310 kPa)
Tyre Size Converter - Wheel View
Side view comparison
Diameter check only
Tread view comparison
Original tyre
Comparison tyre
View recommended tyre size conversions
Diameter matches only: confirm approved sizes, wheel width, clearance, load and speed ratings before fitting. Vehicle-specific limits may be stricter.
Results compare nominal sizes. They do not confirm vehicle or wheel fitment.
Wheel Nut Torque Setting
120 Nm
Follow the numbered order with a torque wrench and the vehicle manufacturer’s procedure.
For other bolt counts, follow the vehicle handbook.
Engine Oil Information
- Engine / Variant
- 3.0 TFSI
3.0 TDI
S7/RS7 4.0 TFSI
later S7 2.9 TFSI (year dependent) - Oil specification
- 3.0 TFSI: VW 502 00/504 00 (later 2019: VW 508 00)
3.0 TDI: VW 507 00
S7/RS7 4.0: VW 502 00/504 00 - Oil capacity
- 3.0 TFSI: 6.8 L (2018) / 7.6 L (2019)
3.0 TDI: 6.4 L
S7/RS7 4.0: 8.7 L
later S7 2.9: 7.6 L — match year/engine
TPMS / Tyre Pressure Monitor Reset
Storing Tyre Pressures
Set all four tyres to the specified pressures. Switch the ignition on. In the MMI select CAR > Car systems > Servicing & checks > Tyre pressure monitoring > Store tyre pressures and confirm. Store them again after any pressure, tyre or wheel change.
