LOADECOFULLY
LADENkPaPSIkPaPSI2403524035————2503627039215/50R17118 Nm
Standard Load Tyre Pressures
Front: 35 PSI (2.4 bar / 240 kPa) - Rear: 35 PSI (2.4 bar / 240 kPa)
Fully Laden Pressures
Front: 36 PSI (2.5 bar / 250 kPa) - Rear: 39 PSI (2.7 bar / 270 kPa)
Tyre Size Converter - Wheel View
Side view comparison
Tread view comparison
View recommended tyre size conversions
Diameter matches only: confirm approved sizes, wheel width, clearance, load and speed ratings before fitting. Vehicle-specific limits may be stricter.
Results compare nominal sizes. They do not confirm vehicle or wheel fitment.
Wheel Nut Torque Setting
118 Nm
Follow the numbered order with a torque wrench and the vehicle manufacturer’s procedure.
For other bolt counts, follow the vehicle handbook.
TPMS / Tyre Pressure Monitor Reset
TPMS reset procedure You should reset TPMS in below situations.• After repairing or replacing tires (or wheels)• After rotating tires• After adjusting tire pressure• When the low tire pressure indicator illuminates• After replacing suspension or ABS system1. Park the vehicle on a level, firm surface.2. Inflate the tires to the proper pressure as indicated on the vehicle's placard or tire inflation pressure label located on the driver's side center pillar outer panel.3. Starting the engine, press and hold the TPMS SET button for about three seconds to reset TPMS.4. Then check that the low tyre pressure indicator turns off after blinking for four seconds. In case of supervision cluster, check that"Tire pressures stored" message is shown on the cluster.5. After resetting the TPMS, drive the vehicle for approximately 20 minutes to store the new tyre pressure in the system.* If the low tire pressure indicator turns on repeat step 3. When resetting TPMS, the current tyre pressure is stored as a standard tyre pressure.Tire pressure monitoring system (TPMS) The TPMS on this vehicle monitors and compares the rolling radius and rotational characteristics of each wheel and tire while you are driving and it checks whether any tire is significantly under-inflated. You should reset the system by pushing the TPMS SET button according to the procedure and this will store the current tire pressure. After that, if one or more tires are significantly under-inflated, the low tire pressure indicator illuminates and a message is shown on the cluster. Also, if there is a malfunction with the TPMS, the TPMS malfunction indicator will illuminate.
